3–5 hour, 18 Volt,
Battery Pack charger
67031
Set uP and oPerating inStructionS
note: Battery Pack (67029) Sold SeParately.
®
distributed exclusively by harbor Freight tools .
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
read this material before using this product.
Failure to do so can result in serious injury.
SaVe thiS manual.
©
®
Copyright 2009 by Harbor Freight Tools . All rights reserved. No portion of this manual or any
artwork contained herein may be reproduced in any shape or form without the express written
consent of Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally.
Due to continuing improvements, actual product may differ slightly from the product described
herein. Tools required for assembly and service may not be included.
For technical questions or replacement parts, please call 1-800-444-3353.
1.
Use on dry, flat, fireproof 8. When battery pack is not in use,
surface only. The Charger
gets hot during use. The
Charger’s heat can build up
keep it away from other metal
objects, like paper clips, coins,
keys, nails, screws or other small
metal objects, that can make a
connection from one terminal to
another. Shorting the battery pack
terminals together may cause burns
or a fire.
to unsafe levels and create a fire
hazard if it does not receive adequate
ventilation, due to an electrical fault,
or if it is used in a hot environment.
Do not place the Charger on a
flammable surface. Do not obstruct
any vents on the Charger. especially
avoid placing the charger on
carpets and rugs; they are not only
flammable, but they also obstruct
vents under the charger.
Place the Charger on a stable, solid,
nonflammable surface (such as a
stable metal workbench or concrete
floor) at least 1 foot away from all
flammable objects, such as drapes or
walls. Keep a fire extinguisher and a
smoke detector in the area.
9. under abusive conditions, liquid
may be ejected from the battery
pack; avoid contact. if contact
accidentally occurs, flush with
water. if liquid contacts eyes,
additionally seek medical help.
Liquid ejected from the battery pack
may cause irritation or burns.
10. Do not expose chargers to rain or wet
conditions. Water entering a Charger
will increase the risk of electric shock.
Charge indoors only.
Frequently monitor the Charger and
battery pack during use.
11. Keep charging area clean and well
lit. Cluttered or dark areas invite
accidents.
2. charge only designated battery
packs; others may overheat, leak,
or burst.
12. Do not operate chargers in explosive
atmospheres, such as in the presence
of flammable liquids, gases or dust.
Chargers create sparks which may
ignite the dust or fumes.
3. Follow charging instructions.
4. do not insert damaged battery
pack.
13. Charger plugs must match the outlet.
Never modify the plug in any way.
Unmodified plugs and matching
outlets will reduce risk of electric
shock.
5. check frequently while charging.
6. Wear anSi-approved safety
goggles during use.
7. Use chargers only with specifically
designated battery packs. Use of
any other battery packs may create a
risk of injury and fire.
14. Do not abuse the cord. Never use
the cord for carrying, pulling or
unplugging the Charger. Keep cord
away from heat, oil, sharp edges or
moving parts. Damaged or entangled
cords increase the risk of electric
shock.
SKU 67031
For technical questions, please call 1-800-444-3353.
Page 3
15. Store idle chargers out of the reach
of children and do not allow persons
unfamiliar with the Charger or these
instructions to operate the Charger.
24. WARNING: Handling the cord on
this product will expose you to lead,
a chemical known to the State of
California to cause cancer, and birth
defects or other reproductive harm.
Wash hands after handling.
16. Maintain chargers. Check for
breakage of parts and any other
condition that may affect the
(California Health & Safety Code §
25249.5, et seq.)
Charger’s operation. If damaged,
have the Charger repaired before use.
SaVe theSe
inStructionS.
17. Have your Charger serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the Charger
is maintained.
18. Inspect before every use; do not use
if parts are loose or damaged.
19. Use as intended only.
20. Unplug after use and before service,
cleaning or storage.
21. Maintain labels and nameplates on
the Charger. These carry important
safety information. If unreadable or
missing, contact Harbor Freight Tools
for a replacement.
22. This product is not a toy. Keep it out
of reach of children.
23. People with pacemakers should
consult their physician(s) before
use. Electromagnetic fields in close
proximity to heart pacemaker could
cause pacemaker interference or
pacemaker failure. In addition,
people with pacemakers should
properly maintain and inspect to avoid
electrical shock.
Page 4
For technical questions, please call 1-800-444-3353.
SKU 67031
shown in the preceding illustration.
(See outlets for 2-Prong Plug.)
grounding
improperly
connecting the
grounding wire can result in
electric shock.
extension cords
Note: Extension cords must not be used
with this Charger.
Check with a qualified
electrician if you are in doubt
as to whether the outlet is
properly grounded. do not
modify the power cord plug
provided with the charger.
do not use the charger if
the power cord or plug is
damaged. if damaged, have it
repaired by a service facility
before use. if the plug will not
fit the outlet, have a proper
outlet installed by a qualified
electrician.
Symbology
Double Insulated
Canadian Standards
Association
Underwriters Laboratories, Inc.
Volts Alternating Current
V~
a
Amperes
double insulated chargers:
chargers with two Prong Plugs
outlets for 2-Prong Plug
1. Chargers marked “Double Insulated”
do not require grounding. They
have a special double insulation
system which satisfies OSHA
requirements and complies with the
applicable standards of Underwriters
Laboratories, Inc., the Canadian
Standard Association, and the
National Electrical Code.
(See outlets for 2-Prong Plug.)
2. Double insulated chargers may be
used in either of the 120 volt outlets
SKU 67031
For technical questions, please call 1-800-444-3353.
Page 5
alignment
tab
SPeciFicationS
Electrical Input
120 V~ / 60 Hz
Electrical Output 22 VDC / 500 mA
Power
indicator
Charge Time
Charging
3-5 hours
67029 - 18 V, 1.3 A, NiCd
Battery Pack (sold separately)
Capability
Figure 4B
unPacking
4. Slide the Charger onto the Battery
Pack until it firmly rests in place
against the alignment tab (see
When unpacking, make sure that
the item is intact and undamaged. If any
parts are missing or broken, please call
Harbor Freight Tools at 1-800-444-3353 as
soon as possible.
Figures 4A and 4B). If the Charger
does not fit properly, disconnect it
and confirm that the Battery Pack is
the correct model for this Charger as
shown on the Specification chart.
do not charge any Battery Pack not
listed or any Battery Pack that the
Charger does not securely fit.
oPerating inStructionS
read the entire imPortant
SaFety inFormation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
5. Attach the Cord to the Charger. The
Power Indicator will light to show that
the power is connected.
1. Place the Battery Pack on a dry
fireproof surface in a room where the
temperature is from 50–104° F.
6. For a fully discharged battery or a
new battery, allow the Battery Pack to
Charge for at least 3 hours.
do not charge the Battery Pack
longer than 5 hours.
2. Allow the Battery Pack to cool
completely before charging.
make sure the battery pack is
undamaged; do not charge a
cracked or leaking battery pack.
WARNING! time the charging cycle.
the battery charger will not signal
when charging is finished.
3. Disconnect the Cord from the
Charger. Attach the plug to a
grounded, 120 V~, 60 Hz outlet.
7. Unplug the Charger and disconnect it
from the Battery Pack when finished.
8. Allow the Battery Pack to cool
completely before using it.
charger
Battery
Pack
9. Store the Charger and Battery Pack
indoors, out of reach of children.
Figure 4a
reV 09h
Page 6
For technical questions, please call 1-800-444-3353.
SKU 67031
PleaSe read the
FolloWing careFully
uSer-maintenance
inStructionS
THE MANUFACTURER AND/OR
DISTRIBUTOR HAS PROVIDED
THE PARTS LIST IN THIS MANUAL
AS A REFERENCE TOOL ONLy.
NEITHER THE MANUFACTURER
OR DISTRIBUTOR MAKES ANy
REPRESENTATION OR WARRANTy OF
ANy KIND TO THE BUyER THAT HE
OR SHE IS qUALIFIED TO MAKE ANy
REPAIRS TO THE PRODUCT, OR THAT
HE OR SHE IS qUALIFIED TO REPLACE
ANy PARTS OF THE PRODUCT. IN
FACT, THE MANUFACTURER AND/
OR DISTRIBUTOR ExPRESSLy
STATES THAT ALL REPAIRS AND
PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN By CERTIFIED
AND LICENSED TECHNICIANS, AND
NOT By THE BUyER. THE BUyER
ASSUMES ALL RISK AND LIABILITy
ARISING OUT OF HIS OR HER REPAIRS
TO THE ORIGINAL PRODUCT OR
REPLACEMENT PARTS THERETO,
OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT
PARTS THERETO.
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
to PreVent
SeriouS injury
From accidental
oPeration:
unplug the charger before
performing any inspection,
maintenance, or cleaning
procedures.
to PreVent SeriouS
injury From charger or
Battery Pack Failure:
do not use damaged charger/
battery pack.
1. BeFore each uSe, inspect the
general condition of the Charger.
Check for loose hardware, cracked
or broken parts, damaged electrical
wiring, and any other condition that
may affect its safe operation.
2. aFter uSe, wipe external surfaces
of the Charger with clean, cloth.
PartS liSt
3. ni-cd Battery muSt Be
recycled or diSPoSed
Part
1
description
Charger
oF ProPerly. do not short,
incinerate or open Battery Pack.
2
AC/DC Adapter
record Product’s Serial number here:
Note: If product has no serial number,
record month and year of purchase
instead.
Note: Some parts are listed for illustration
purposes only, and are not available
individually as replacement parts.
SKU 67031
For technical questions, please call 1-800-444-3353.
Page 7
To take advantage of this warranty,
the product or part must be returned to us
with transportation charges prepaid. Proof
of purchase date and an explanation of the
complaint must accompany the merchan-
dise. If our inspection verifies the defect,
we will either repair or replace the product
at our election or we may elect to refund
the purchase price if we cannot readily
and quickly provide you with a replace-
ment. We will return repaired products at
our expense, but if we determine there
is no defect, or that the defect resulted
from causes not within the scope of our
warranty, then you must bear the cost of
returning the product.
limited 90 day Warranty
Harbor Freight Tools Co. makes ev-
ery effort to assure that its products meet
high quality and durability standards, and
warrants to the original purchaser that this
product is free from defects in materials
and workmanship for the period of 90 days
from the date of purchase. This warranty
does not apply to damage due directly or
indirectly, to misuse, abuse, negligence or
accidents, repairs or alterations outside
our facilities, criminal activity, improper
installation, normal wear and tear, or to
lack of maintenance. We shall in no event
be liable for death, injuries to persons
or property, or for incidental, contingent,
special or consequential damages arising
from the use of our product. Some states
do not allow the exclusion or limitation
of incidental or consequential damages,
so the above limitation of exclusion may
not apply to you. THIS WARRANTy IS
ExPRESSLy IN LIEU OF ALL OTHER
WARRANTIES, ExPRESS OR IMPLIED,
INCLUDING THE WARRANTIES OF
MERCHANTABILITy AND FITNESS.
This warranty gives you specific
legal rights and you may also have other
rights which vary from state to state.
3491 Mission Oaks Blvd. • PO Box
6009 • Camarillo, CA 93011 • (800)
444-3353
Page 8
For technical questions, please call 1-800-444-3353.
SKU 67031
|